Navigator 600 Silica
Single-stream Appendix B – Diagnostics and Alarms
72 IM/NAV6S/SS–EN Rev. E
Out of Cleaning Solution
The cleaning solution bottle is empty.
1. Replace the cleaning solution.
2. At the 'Calibration & Maintenance' level, select 'Solution
Replacement' and at the 'Replace Cleaning Solution'
parameter, press the key to confirm that solution has
been replaced.
Scheduled
cleans
Out of Secondary Calibration Solution
The secondary calibration solution bottle is empty.
1. Replace the secondary calibration solution.
2. At the 'Calibration & Maintenance' level, select 'Solution
Replacement' and at the 'Replace Sec. Calibration Solution'
parameter, press the key to confirm that solution has
been replaced.
Scheduled
secondary
calibration
* Limits can be set – see Section 5.4.3, page 33
Icon Diagnostic message
Out-of-
Service
Relay
Hold
Relay
Cal. in
Progress
Relay
Cal.
Failed
Relay
Inhibits
Table B.1 Diagnostic Information, Relay Operations and Inhibits (Sheet 7 of 7)
To Next Page
Loading...
