ABB OmniCore V250XT - Page 125

NoteArticle numberSpare part
DSQC 6093HAC14178-1DSQC 609 power supply
DSQC 6343HAC13398-2DSQC 634 power supply
DSQC 6093HAC071467-001Harness PSU 24V
3HAB7983-1End clamp
DSQC 609 and DSQC 6343HAC071187-001Harness PSU
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 414.
-Standard toolkit
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC074000-008Circuit diagram - OmniCore
V250XT
Installing the optional power supply
Preparations
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 28.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 43.
2
xx2100000318
Continues on next page
Product manual - OmniCore V250XT 125
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
3 Installation and commissioning
3.7.4 Installing the power supply optional device
Continued