Note/IllustrationAction
Remove the screws and lift out the robot
signal exchange proxy.
3
Installing the DeviceNet board
Note/IllustrationAction
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
When handling the computer outside of
the controller, use the wrist strap button
located on the side of the computer.
1
xx2000000419
xx1800003415
Remove the screws on top of the main
computer and take the cover off.
2
xx1800003414
Remove the attachment screw on the
cover of the fieldbus master and take out
the cover.
3
Continues on next page
132 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
3 Installation and commissioning
3.7.5 Installing the fieldbus master
Continued
To Next Page
Loading...
