Info/illustrationAction
xx2100000314
Remove the screws.2
Remove the rear cover.3
Refitting the controller covers
Preparations
Info/illustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 28.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 43.
2
xx2100000318
Refitting the rear cover
Info/illustrationAction
Refit the the rear cover.1
Continues on next page
178 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.2.1 Opening the robot controller
Continued
To Next Page
Loading...
