Removing the digital base (option)
Note/IllustrationAction
Disconnect:
• K5.1.X5/K3.1.X5 - A2.X4/K4.X7
Note
If the Ethernet extension switch is
installed, connect and disconnect
the connector K5.1.X5/K3.1.X5
to/from K4.X7.
If the Ethernet extension switch is
not installed, connect and discon-
nect the connector
K5.1.X5/K3.1.X5 to/from A2.X4.
• K5.1.X4 - K2.X3
• The harness connected to I/O unit
by customer.
1
xx1900002446
Push the buckle of the digital base
slightly and take out the digital base.
2
xx1900002447
Continues on next page
Product manual - OmniCore V250XT 219
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.2.6 Replacing the scalable I/O unit
Continued
To Next Page
Loading...
