5.2.9 Replacing the power unit
Location
The illustration shows the location of the power unit in the controller.
xx2100000321
WARNING
Do not touch the power unit when the DC-BUS High Voltage LED is on.
There is residual voltage in the power unit even if the main switch is in the OFF
position.
Continues on next page
250 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.2.9 Replacing the power unit
To Next Page
Loading...
