Note/IllustrationAction
Connect the adapter cable to the convey-
or tracking module.
• B1.X1 - K2.X5
• B1.X7 - K4.X1-X5
Stick the other connector onto the side
of the digital base with the self-adhesive
part.
4
Concluding procedure
Note/IllustrationAction
Closing the door on page 176.Close the door.1
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 166.
2
Product manual - OmniCore V250XT 297
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.2.15 Replacing the conveyor tracking module (CTM)
Continued
To Next Page
Loading...
