ABB OmniCore V250XT - Page 318

Note/IllustrationAction
Screws: Torx, countersunk screw M4x10 (4
pcs)
Insert the HMI signal connector into the
cover from inside the cabinet.
3
xx2100000832
Secure it with the screws.
Connect:
• TPU (X4) - K2.X9 & X13
4
Secure the cables on HMI signal connect-
or with new cable ties.
Tip
Use the same position as from removing
the HMI signal connector.
5
xx2100000831
Refit the cover plate.6
Continues on next page
318 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.3.3 Replacing the HMI signal (FlexPendant) connector
Continued