SignificanceDescription
Three (3) LEDs indicating the Wi-Fi or 3G signal level.
• ON: The unit is connected to the network and working ok.
• OFF: Problem with connector, antenna, or sim card.
RF, signal
strength status
LEDs
Required test equipment
Equipment needed for troubleshooting:
NoteEquipment
Multimeter
Insulating gloves
Preparations
Action
Check the FlexPendant for errors and warnings.1
Power the controller off. Wait one minute, power the controller on.2
Wait 30-60 seconds after power-on.3
Make sure that the control system power is in run-time mode.
Continues on next page
392 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
7 Troubleshooting
7.3.6 Troubleshooting the connected services gateway
Continued
To Next Page
Loading...
