Use this procedure to mount the bracket for the emergency stop to the FlexPendant
holder.
Note/illustrationAction
xx2000002356
Remove the four screws.1
Separate the rear part from the FlexPend-
ant holder.
2
xx2100000765
Insert the bracket into the FlexPendant
holder.
3
Screws: BN33 Phillips pan head tapping
screw ST2.9x13 (3 pcs)
Secure with the screws.4
Tightening torque: 6 Nm-7.8 Nm
xx2100000766
Continues on next page
60 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.3 Mounting the FlexPendant holder
Continued
To Next Page
Loading...
