Note/illustrationAction
Screws: BN33 Phillips pan head tapping
screw ST3.5x16 (4 pcs)
Refit the rear part and secure with the
screws.
5
Tightening torque: 9.4 Nm-12.2 Nm
xx2000002356
Mounting the FlexPendant holder onto a flat surface (Horizontally)
Use this procedure to mount the FlexPendant holder onto a flat surface, like the
top of the controller or a desktop.
Note/illustrationAction
Clean the surface and make sure it is dry.1
xx2000002352
Remove the protective liner from the
tape.
2
Continues on next page
Product manual - OmniCore V250XT 61
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.3 Mounting the FlexPendant holder
Continued
To Next Page
Loading...
