Installing cables with the cable grommet assembly
Preparations
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Opening the door on page 182.Open the door.2
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
3
xx2300001842
Removing the slot cover (baseline)
Note/IllustrationAction
xx2100001282
Remove the attachment screws.1
Take out the cover from the inside of the
controller.
2
Continues on next page
Product manual - OmniCore V400XT 139
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
3 Installation and commissioning
3.7.7 Installing the cable grommet assembly
Continued
To Next Page
Loading...
