ABB OmniCore V400XT - Page 207

Refitting the Ethernet extension switch (option)
Refitting the Ethernet extension switch (option)
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
2
xx2300001842
xx2300001835
Hook up the Ethernet extension switch
to the bracket and then push the switch
into position.
Note
During the installation, there should be
no gap between the upper surface of the
Ethernet extension switch and the lower
surface of highest bracket on the main
computer.
xx1800000972
3
Reconnect any connectors disconnected
at removal.
4
Continues on next page
Product manual - OmniCore V400XT 207
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.3 Replacing the Ethernet switch (DSQC1035)
Continued