Refitting the DSQC 609 power supply
Refitting the power supply
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
2
xx2300001842
Screws: Cross recessed cheese head screw
M4x8 (1 pcs)
Fit the power supply to the bracket and
fasten it with screw.
3
Tightening torque: 1.7 Nm±10%.
xx1900001908
Reconnect any connectors disconnected
at removal.
4
Continues on next page
254 Product manual - OmniCore V400XT
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.12 Replacing the power supply
Continued
To Next Page
Loading...
