Note/IllustrationAction
xx1900001907
Refit the end clamp besides the power
supply.
5
Concluding procedure
Note/IllustrationAction
Closing the door on page 183.Close the door.1
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 171.
2
Removing the DSQC 634 power supply
Preparations
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Opening the door on page 182.Open the door.2
Continues on next page
Product manual - OmniCore V400XT 255
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.12 Replacing the power supply
Continued
To Next Page
Loading...
