ABB OmniCore V400XT - Replacing the Drive Unit

5.2.13 Replacing the drive unit
Location
The illustration shows the location of the drive unit in the controller.
xx2300001794
WARNING
Do not touch the drive unit when the DC-BUS High Voltage LED is on.
There is residual voltage in the drive unit even if the main switch is in the OFF
position.
Continues on next page
Product manual - OmniCore V400XT 259
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.13 Replacing the drive unit