Note/IllustrationAction
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
3
xx2300001842
Removing the drive unit
Note/IllustrationAction
Disconnect all connectors from the unit
to be replaced.
1
Lengthened screwdriverRemove the screws and pull the drive
unit out from the two guiding pins on the
mounting plate.
CAUTION
The weight of the drive unit is 11 kg.
Use protective gloves when lifting this
unit.
2
xx2100000338
CAUTION
The cabling is sensitive to mechanical
damage. Handle it with care to avoid
damage to the cabling or the connector,
avoid any kind of tilt or skew.
Continues on next page
Product manual - OmniCore V400XT 261
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.13 Replacing the drive unit
Continued
To Next Page
Loading...
