ABB OmniCore V400XT - Page 267

Refitting the additional drive unit
Refitting the additional drive unit
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
2
xx2300001842
Screws: Torx pan head screw M4x8 (4 pcs)Refit the additional drive unit and secure
with the screws.
3
Tightening torque: 2 Nm
xx2200001375
Reconnect any connectors disconnected
at removal.
4
Concluding procedure
Note/IllustrationAction
Closing the door on page 183.Close the door.1
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 171.
2
Product manual - OmniCore V400XT 267
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.14 Replacing the additional drive unit
Continued