Note/IllustrationAction
xx2200001074
Secure the screw holding the break res-
istor bleeder bracket.
4
Reconnect any connectors disconnected
at removal.
5
Concluding procedure
Note/IllustrationAction
Refitting the rear cover on page 185.Refit the rear cover of the controller.1
Closing the door on page 183.Close the door.2
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 171.
3
Product manual - OmniCore V400XT 285
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.18 Replacing the break resistor bleeder
Continued
To Next Page
Loading...
