ABB OmniCore V400XT - Replacing Parts on the Front Panel and Door

5.3 Replacing parts on the front panel and door
5.3.1 Replacing the manipulator signal connector (SMB)
Location
The illustration shows the location of the manipulator signal connector.
xx2100000826
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore V400XT via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
Harness 1xSMB3HAC081735-001Harness SMB connection
Harness 1xSMB3HAC077440-001Harness SMB link
Harness 2xSMB3HAC077388-001Harness SMB link
LV3HAC083231-001Harness SMB link
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 424.
-Standard toolkit
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC082020-008Circuit diagram - OmniCore
V400XT
Continues on next page
286 Product manual - OmniCore V400XT
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.3.1 Replacing the manipulator signal connector (SMB)