ABB OmniCore V400XT - Page 333

Refitting the measurement unit
Note/IllustrationAction
xx2300001706
Refit the measurement unit on the
mounting plate and tighten the screws.
1
Put the measurement unit and mounting
plate in the box.
2
xx2300001705
Refit the screws at the front of the box.3
Reconnect any connectors disconnected
at removal.
4
Continues on next page
Product manual - OmniCore V400XT 333
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.5.2 Replacing the measurement unit
Continued