Safety 11
Safety
Chapter contents
• Use of warnings and symbols (p. 11)
• Warning labels on the inverter (p. 13)
• Intended use (p. 14)
• Safety during installation and maintenance (p. 14)
• General safety (p. 14)
• Electrical safety (p. 15)
• Safe start-up and operation (p. 18)
Obey the safety instructions when you install, operate and do maintenance on the
inverter. Obey these instructions to prevent physical injury or death, and damage to
the inverter or to connected equipment.
Use of warnings and symbols
These warnings and symbols are used in this document and on the equipment:
Risk of electric shock. This warning identifies dangerous electrical conditions
which can cause injury, death and damage to the equipment.
Risk of electric shock for indicated time after isolation. After you isolate the
equipment, wait the indicated time before you do work on the equipment.
This warning identifies dangerous electrical conditions which can cause
injury, death and damage to the equipment.
Risk of danger. This warning identifies dangerous non-electrical conditions
which can cause injury, death and damage to the equipment.
Hot surface. This warning identifies areas which can cause injury due to heat.
To Next Page
Loading...
