14 Safety
Intended use
Use the inverter only as part of a photovoltaic system when it is permanently
connected to the electrical grid.
Safety during installation and maintenance
Obey the local regulations and standards and the instructions in this manual, when
you do work on the:
•Inverter
• Input and output cabling
• Photovoltaic arrays
General safety
WARNING! Obey these instructions to prevent injury or death, or damage to
the equipment.
• Do not repair a malfunctioning unit. Contact your supplier, the local ABB
representative or an Authorized Service Center for instructions.
• Make sure that dust or water does not go into the inverter during installation.
• Use a hoist to lift the inverter. The inverter is heavy.
• Make sure that cooling air inlets and outlets of the inverter are open.
To Next Page
Loading...
