Mechanical installation 43
Unpack the delivery
1. Examine the package for damage.
2. Before you open the package, read the package labels to make sure that the
delivery is correct.
3. Move the inverter in its package to the installation area.
4. Open the shipping cover and examine the contents. Make sure that the package
contains the installation accessories:
• Wall-mounting plate, locking screws M5x20 T25 stainless steel and washers
• AC connector housing
• Reducer seal for the AC cable gland
• 2 M25 and 1 M32 reducer seals for single-cables in the control cable glands
• 2 lifting eye bolts M10
• Quick installation and start-up guide
5. Examine the type designation label on the inverter to make sure that it is the
correct unit. Refer to Model identification label on page 29 and Accessories on
page 31.
6. Do not remove items from the package until you are ready to install them.
7. Read the instructions and keep them available at the installation area.
Refer to Move the unit on page 46 before you move the inverter.
To Next Page
Loading...
