Mechanical installation 47
Vertical installation to the wall-mounting plate
1. Tilt the unit to the upright position.
2. Lift the inverter from the lifting positions (a) on the sides of the connection area
and stabilize it from the top.
3. Move the inverter on to the wall-mounting plate so that the inverter is slightly
above the wall-mounting plate (b).
4. Lower the inverter into the hook on the wall-mounting plate (c).
5. Install and tighten the 2 M5x20 (T25) screws and washers (one on each side) to
secure the inverter (d) to the wall-mounting plate.
6. Use a padlock to prevent unauthorized removal (e).
7. If it is necessary, remove the eye bolts.
To Next Page
Loading...
