ABB PRO-33.0-TL Series - Control Cable Connections; Connection Area Layout

62 Electrical installation
Control cable connections
Refer to Control cable requirements on page 38.
 Connection area layout
No. Description
1 Status LEDs on control board.
2 X8 RJ45 data type 8P8C plug connector, RS-485 interface for control unit.
3 Control unit support (that can be used as a wall-mounting support).
4 X1 remote control unit spring terminal (RS-485 interface).
5 S1:1 Selector switch, not in use, default always OFF.
S1:2 Selector switch for embedded fieldbus network termination (ON), default OFF.
6 X2 remote monitoring spring terminal.
7 Connector for internal fan (Int. Fan).
8 SLOT 1 and SLOT 2 for Fieldbus option modules.
9 Clamp connectors to connect cable shields to protective earth.
10 Cable glands for control cables (1x M32 and 2x M25).
11 Additional PE terminal.
1 2 3 4 5 6
1 2 3
SW1
SLOT 1 SLOT 2
X2X1
INT FAN
1
7
8
11
6
5
4
2
10
9
3