Start-up 77
Select Time and push the right arrow key.
Set the time with the up and down arrow keys. Use
the right and left arrow keys to move between the
hours, minutes and seconds.
Push the right softkey to save the time.
Select Show date as and push the right arrow key.
Select the date format and push the right softkey
to save the format.
Select Show time as and push the right arrow key.
Select the time format and push the right softkey
to save the format.
To set the grid code settings, select Country code
and push the right arrow key.
Refer to List of country codes on page 79.
Select the country code with the left and right
arrow keys. This sets the correct grid connection
parameters for the location. If the installation
country is not in the list, contact your supplier to
make sure that the inverter can be used in your
country.
Push the right softkey to save the installation
country.
First start-up procedures
To Next Page
Loading...
