1MRK 505 353-UEN Section 3
Configuring bay protection using HMI500
Application Manual 25
Bay protection functions REB500
3.4.1.3 Assignment of ‘BP internal’ input signals
Click the left mouse button on the status button of the desired signal to open the di-
alog “Select Binary Input” for configuring the status of the particular binary input
signal.
The dialog has two tabs, the first of which (“TRUE / FALSE”) provides facility for
setting the input status to “Always True”, OR “Always False”. This is a permanent
assignment, without the involvement of an output signal of another function.
Figure 11 Configuring binary inputs (TRUE / FALSE)
The second tab “Output from Function” enables the output of an existing instance
of a protection function to be connected to the particular signal input.
The “Output from Function” tab lists all the protection function instances set for
the particular bay unit together with the unique number of the instance. Upon se-
lecting a protection function in the list on the left by clicking the left mouse button
on it, its binary output signals appear on the right of the dialog.
To Next Page
Loading...
