ABB REB500 - Page 34

Section 3 1MRK 505 353-UEN
Configuring bay protection using HMI500
26 Application Manual
Bay protection functions REB500
Figure 12 Configuring binary inputs (Output from other BP function)
Table 41 “Output from Function”- dialogue / Column designations
Dialogue tem Description
Channel
Unique No. of the output signal
Inv
Check this box to invert the signal
Signal text
Output signal name
Location of ‘BP internal’ input signals within the BP function dia-
gram see Figure 1, Label No. 18.
3.4.1.4 Assignment ‘BP external’ input signals
The system automatically creates an instance “BP Binary Input”. It thus always
heads the list of instances.
If you select “BP Binary Input”, the right-hand half of the dialog presents two tabs
“Default” and “General purpose”.