Section 3 1MRK 505 353-UEN
Configuring bay protection using HMI500
28 Application Manual
Bay protection functions REB500
Example:
Signal name under the BP function Designation of binary input signals to be entered under
“General Purpose”
111205_DIST Ext. Block Dist.
Figure 14 Configuring binary inputs (General purpose)
Location of ‘BP internal’ input signals within the BP function dia-
gram see Figure 1, Label No. 11.
Once defined, signals can be assigned to an optocoupler input by selecting the
menu “Configuration/ Binary module/ Inputs”.
Location of ‘Binary module’ input signals within the BP function
diagram see Figure 1, Label No. 10.
To Next Page
Loading...
