1MRK 505 353-UEN Section 3
Configuring bay protection using HMI500
Application Manual 31
Bay protection functions REB500
General Purpose
The “General Purpose” tab provides facility for defining up to 120 output signals.
Figure 18 BP output (General purpose)
Location of “BP general purpose” output signals within the BP
function diagram see Figure 1, Label No. 12.
Edit (used for both “Default” and “General purpose” signals
Click on the respective “Edit” button to assign a “Default” or “General purpose”
signal. This opens the dialog “Select binary input”. The remaining procedure is the
same as described for binary input signals (see Section 3.4.1.4).
Only bay protection output signals that are configured to a BP
Output Channel can be assigned to an output relay of the bay unit
by selecting the menu “Configuration/ Binary module/ Outputs”.
Section 2.3.2.4 provides a list of available bay protection output
signals.
Location of Binary module’ output signals within the BP function
diagram see Figure 1, Label No. 13.
To Next Page
Loading...
