ABB REB650 - Analog Input Signals A4 RADR

Name Values (Range) Unit Step Default Description
UnderTrigLe09 0 - 200 % 1 50 Under trigger level for analog channel 9 in %
of signal
OverTrigOp09 Disabled
Enabled
- - Disabled Use over level trigger for analog channel 9
(on) or not (off)
OverTrigLe09 0 - 5000 % 1 200 Over trigger level for analog channel 9 in % of
signal
NomValue10 0.0 - 999999.9 - 0.1 0.0 Nominal value for analog channel 10
UnderTrigOp10 Disabled
Enabled
- - Disabled Use under level trigger for analog channel 10
(on) or not (off)
UnderTrigLe10 0 - 200 % 1 50 Under trigger level for analog channel 10 in %
of signal
OverTrigOp10 Disabled
Enabled
- - Disabled Use over level trigger for analog channel 10
(on) or not (off)
OverTrigLe10 0 - 5000 % 1 200 Over trigger level for analog channel 10 in %
of signal
12.3.4 Analog input signals A4RADR
12.3.4.1 Identification
Function description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Analog input signals A4RADR - -
12.3.4.2 Function block
A4RADR
^INPUT31
^INPUT32
^INPUT33
^INPUT34
^INPUT35
^INPUT36
^INPUT37
^INPUT38
^INPUT39
^INPUT40
IEC09000350-1-en.vsd
IEC09000350 V1 EN
Figure 112: A4RADR function block, derived analog inputs
Channels 31-40 are not shown in LHMI. They are used for internally
calculated analog signals.
Section 12 1MRK 505 277-UUS C
Monitoring
262
Technical Manual