IEC17000044 V1 EN-US
Figure 206: Merging unit
16.3.2 Setting guidelines
GUID-3449AB24-8C9D-4D9A-BD46-5DDF59A0F8E3 v1
For information on the merging unit setting guidelines, see section
IEC/UCA 61850-9-2LE
communication protocol.
16.4 Routes
16.4.1 Application
GUID-19616AC4-0FFD-4FF4-9198-5E33938E5ABD v1
Setting up a route enables communication to a device that is located in another subnetwork.
Routing is used when the destination device is not in the same subnetwork as the default
gateway.
The route specifies that when a package is sent to the destination device it should be sent
through the selected router. If no route is specified the source device will not find the
destination device.
16.4.2 Setting guidelines
GUID-2C4A312A-00DC-44C8-B2D9-CD0822E1C806 v1
Routes are configured using the Ethernet configuration tool in PCM600.
Operation
for the route can be set to
On
/
Off
by checking and unchecking the check-box in the
operation column.
Gateway
specifies the address of the gateway.
Destination
specifies the destination.
Destination subnet mask
specifies the subnetwork mask of the destination.
1MRK 505 370-UEN D Section 16
Ethernet-based communication
Busbar protection REB670 391
Application manual
To Next Page
Loading...
