ABB REC650 ANSI - Monitored Data

Name Values (Range) Unit Step Default Description
IMagComp5 -10.000 - 10.000 % 0.001 0.000 Magnitude factor to calibrate current at 5% of In
IMagComp30 -10.000 - 10.000 % 0.001 0.000 Magnitude factor to calibrate current at 30% of
In
IMagComp100 -10.000 - 10.000 % 0.001 0.000 Magnitude factor to calibrate current at 100%
of In
IAngComp5 -10.000 - 10.000 Deg 0.001 0.000 Angle calibration for current at 5% of In
IAngComp30 -10.000 - 10.000 Deg 0.001 0.000 Angle calibration for current at 30% of In
IAngComp100 -10.000 - 10.000 Deg 0.001 0.000 Angle calibration for current at 100% of In
12.1.3.5 Monitored data
Table 346: CMMXU Monitored data
Name Type Values (Range) Unit Description
I_A REAL - A IA Amplitude
IA_ANGL REAL - deg IA Angle
I_B REAL - A IB Amplitude
IB_ANGL REAL - deg IB Angle
I_C REAL - A IC Amplitude
IC_ANGL REAL - deg IC Angle
12.1.4 Phase-phase voltage measurement VMMXU
12.1.4.1 Identification
Function description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Phase-phase voltage measurement VMMXU
U
SYMBOL-UU V1 EN
-
12.1.4.2 Function block
The available function blocks of an IED are depending on the actual hardware (TRM) and
the logic configuration made in PCM600.
Section 12 1MRK 511 287-UUS A
Monitoring
428
Technical manual