Table 543: Output contacts X336, 3U full 19”
Terminal Description PCM600 info
Hardware module
instance
Hardware channel
X336-1 Power output 1, normally open BIO_6 BO1_PO
X336-2
X336-3 Power output 2, normally open BIO_6 BO2_PO
X336-4
X336-5 Power output 3, normally open BIO_6 BO3_PO
X336-6
16.3.2 Outputs for signalling
Signal output contacts are used for signalling on starting and tripping of the IED. On
delivery from the factory, the pickup and alarm signals from all the protection stages are
routed to signalling outputs. See connection diagrams.
Each signal connector terminal is connected with one 14 or 16 Gauge wire.
Table 544: Output contacts X317, 3U full 19”
Terminal
Description PCM600 info
Hardware module
instance
Hardware channel
X317-13 Signal output 1, normally open PSM_102 BO7_SO
X317-14
X317-15 Signal output 2, normally open PSM_102 BO8_SO
X317-16
X317-17 Signal output 3, normally open PSM_102 BO9_SO
X317-18
Table 545: Output contacts X321, 3U full 19”
Terminal
Description PCM600 info
Hardware module
instance
Hardware channel
X321-7 Signal output 1, normally open BIO_3 BO4_SO
X321-8 Signal output 1
X321-9 Signal output 2, normally open BIO_3 BO5_SO
X321-10 Signal output 2
X321-11 Signal output 3, normally open BIO_3 BO6_SO
Table continues on next page
1MRK 511 287-UUS A Section 16
IED physical connections
639
Technical manual
To Next Page
Loading...
