ABB REG316 4 Series - Page 640

Numerical generator protection REG316*4
1MRK502004-Ben
Page 12
Technical data Hard-
ware (cont’d)
Technical data Hard-
ware (cont’d)
ABB Switzerland Ltd
Utility Automation
Table 7: Auxiliary supply
Table 8: General data
Supply voltage
Voltage range 36 to 312 V DC
Voltage interruption bridging time >50 ms
Fuse rating ³4 A
Load on station battery at normal operation
(1 relay energized) <20 W
during a fault
(all relays energized)
with 1 I/O unit
with 2 I/O units
with 3 I/O units
with 4 I/O units
<22 W
<27 W
<32 W
<37 W
Additional load of the options
SPA, IEC 60870-5-103 or LON interface
MVB interface
1.5 W
2.5 W
Buffer time of the event list and fault recorder data at
loss of auxiliary supply
>2 days (typ. 1 month)
Temperature range
operation
storage
-10° C to +55° C
-40° C to +85° C
EN 60255-6 (1994),
IEC 60255-6 (1988)
Humidity 93%, 40° C, 4 days IEC 60068-2-3 (1969)
Seismic test 5 g, 30 s, 1 to 33 Hz
(1 octave/min)
IEC 60255-21-3 (1995),
IEEE 344 (1987)
Leakage resistance >100 MW, 500 V DC EN 60255-5 (2001),
IEC 60255-5 (2000)
Insulation test 2 kV, 50 Hz, 1 min
1 kV across open contacts
EN 60255-5 (2001),
IEC 60255-5 (2000),
EN 60950 (1995)
Surge voltage test 5 kV, 1.2/50 ms EN 60255-5 (2001),
IEC 60255-5 (2000) *
1 MHz burst disturbance test 1.0/2.5 kV, Cl. 3; 1MHz,
400 Hz rep.freq.
IEC 60255-22-1 (1988),
ANSI/IEEE C37.90.1
(1989)
Fast transient test 2/4 kV, Cl. 4 EN 61000-4-4 (1995),
IEC 61000-4-4 (1995)
Electrostatic discharge test
(ESD)
6/8 kV (10 shots), Cl. 3 EN 61000-4-2 (1996),
IEC 61000-4-2 (2001)
Immunity to magnetic interfer-
ence at power system frequen-
cies
300 A/m; 1000 A/m; 50/60 Hz
EN 61000-4-8 (1993),
IEC 61000-4-8 (1993)
Radio frequency interference test
(RFI)
• 0.15-80 MHz, 80% amplitude modulated
10 V, Cl. 3
• 80-1000 MHz, 80% amplitude modulated
10 V/m, Cl. 3
• 900 MHz, puls modulated
10 V/m, Cl. 3
EN 61000-4-6 (1996)
EN 61000-4-6 (1996),
EN 61000-4-3 (1996),
IEC 61000-4-3 (1996),
ENV 50204 (1995)
Emission Cl. A EN 61000-6-2 (2001),
EN 55011 (1998),
CISPR 11 (1990)
* Reduced values apply for repeat tests according to IEC publication 255-5, Clauses 6.6 and 8.6.