Function type is selected with parameter FunctionType.
Information number is defined for each output signals.
Table 777: I103IEDCMD supported indications
INF
Description
19 LED Reset
23 Activate setting group 1
24 Activate setting group 2
25 Activate setting group 3
26 Activate setting group 4
Function commands in control direction, pre-defined I103CMD
Function command block in control direction with defined output signals.
Number of instances: 1
Function type is selected with parameter FunctionType.
Information number is defined for each output signals.
Table 778: Pre-defined I103CMD supported indications
INF
Description
16 Auto-recloser on/off
17 Teleprotection on/off
18 Protection on/off
Function commands in control direction, user-defined, I103USRCMD
Function command blocks in control direction with user-defined output signals.
Number of instances: 4
Function type for each function block instance in private range is selected with
parameter FunctionType.
Information number must be selected for each output signal. Default values are 1 - 8.
Table 779: I103USRCMD supported indications
INF
1)
Description
1 Output signal 01
2 Output signal 02
3 Output signal 03
4 Output signal 04
5 Output signal 05
Table continues on next page
1MRK502052-UEN B Section 18
Station communication
1051
Technical manual
To Next Page
Loading...
