ABB REG670 - Settings

Table 851: TESTMODE Output signals
Name Type Description
TEST BOOLEAN In test via IED TEST or via LD0 Mode
IED_TEST BOOLEAN IED test mode is active
BLOCK BOOLEAN Active when LD0 is blocked or test blocked
NOEVENT BOOLEAN Event disabled during test mode
INPUT BOOLEAN IED TEST input is active
SETTING BOOLEAN IED test mode setting is On
IEC61850 BOOLEAN Active when LD0 Mode is in Blocked, Test or Test
blocked
20.9.4 Settings
Table 852: TESTMODE Non group settings (basic)
Name Values (Range) Unit Step Default Description
IEDTestMode Off
On
- - Off Activate IED Test mode
EventDisable Off
On
- - Off Event disable during test mode
BlockAllFunc Off
On
- - On Block all functions when entering IED test
mode
CmdTestEd1 Off
On
- - Off Require test bit in command at test mode
(only for IEC61850 Ed1)
20.9.5 Operation principle
Put the IED into test mode to test functions in the IED. Set the IED in test mode by
• configuration, activating the input SIGNAL on the function block TESTMODE.
• setting TestMode to On in the local HMI, under Main menu/TEST/IED test
mode.
While the IED is in test mode, the output ACTIVE of the function block TESTMODE
is activated. The outputs of the function block TESTMODE shows the cause of the
“Test mode: being in On” state. If the input from the configuration (OUTPUT signal
is activated) or setting from local HMI (SETTING signal is activated).
While the IED is in test mode, the yellow START LED will flash and all functions are
blocked. Any function can be unblocked individually regarding functionality and
event signalling.
The deblocking is reseted when exiting test mode.
The blocking of a function concerns all output signals from the actual function, so no
outputs will be activated.
1MRK502052-UEN B Section 20
Basic IED functions
1121
Technical manual