ABB REG670 - Technical Data

Name Type Values (Range) Unit Description
CH4 REAL - A Service value analog
input 4
CH5 REAL - A Service value analog
input 5
CH6 REAL - A Service value analog
input 6
21.2.11.6 Technical data
Table 917: MIM - mA input module
Quantity: Rated value: Nominal range:
Input resistance R
in
= 194 Ohm -
Input range ± 5, ± 10, ± 20mA
0-5, 0-10, 0-20, 4-20mA
-
Power consumption
each mA-board
each mA input
£ 2 W
£ 0.1 W
-
21.2.12 Serial and LON communication module (SLM)
21.2.12.1 Introduction
The serial and LON communication module (SLM) is used for SPA, IEC
60870-5-103, DNP3 and LON communication. The module has two optical
communication ports for plastic/plastic, plastic/glass or glass/glass. One port is used
for serial communication (SPA, IEC 60870-5-103 and DNP3 port) and one port is
dedicated for LON communication.
21.2.12.2 Design
The SLM is a PMC card and it is factory mounted as a mezzanine card on the NUM
module. Three variants of the SLM are available with different combinations of
optical fiber connectors, see figure
537. The plastic fiber connectors are of snap-in
type and the glass fiber connectors are of ST type.
1MRK502052-UEN B Section 21
IED hardware
1185
Technical manual