and the block names are fully settable by the user. These names will appear in the
menu, so the user can see the position names instead of a number.
14.5.7.1 Graphical display
There are two possibilities for SLGAPC
• if it is used just for the monitoring, the switches will be listed with their actual
position names, as defined by the user (max. 13 characters).
• if it is used for control, the switches will be listed with their actual positions, but
only the first three letters of the name will be used.
In both cases, the switch full name will be shown, but the user has to redefine it when
building the Graphical Display Editor, under the "Caption". If used for the control, the
following sequence of commands will ensure:
Section 14 1MRK502052-UEN B
Control
764
Technical manual
To Next Page
Loading...
