ABB REG670 - Page 60

IEC 61850 or function
name
ANSI Function description Generator
REG670
(Customized)
REG670 (A20) REG670 (B30)
REG670 (C30)
RCHLCCH Access point diagnostic for
redundant Ethernet ports
3 3 3 3
DHCP DHCP configuration for front access
point
1 1 1 1
QUALEXP IEC 61850 quality expander 96 96 96 96
Remote communication
BinSignRec1_1
BinSignRec1_2
BinSignReceive2
Binary signal transfer receive 3/3/6 3/3/6 3/3/6 3/3/6
BinSignTrans1_1
BinSignTrans1_2
BinSignTransm2
Binary signal transfer transmit 3/3/6 3/3/6 3/3/6 3/3/6
BinSigRec1_12M
BinSigRec1_22M
BinSigTran1_12M
BinSigTran1_22M
Binary signal transfer, 2Mbit receive/
transmit
3 3 3 3
LDCMTRN Transmission of analog data from
LDCM
1 1 1 1
LDCMTRN_2M Transmission of analog data from
LDCM, 2Mbit
6 6 6 6
LDCMRecBinStat1
LDCMRecBinStat2
LDCMRecBinStat3
Receive binary status from remote
LDCM
6/3/3 6/3/3 6/3/3 6/3/3
LDCMRecBinS2_2M Receive binary status from LDCM,
2Mbit
3 3 3 3
LDCMRecBinS3_2M Receive binary status from remote
LDCM, 2Mbit
3 3 3 3
Table 7: Number of function instances in Synchrophasor report, 16 phasors
Function name
Function description Number of instances
PMUCONF Configuration parameters for C37.118 2011 and IEEE1344 protocol 1
PMUREPORT Protocol reporting via IEEE 1344 and C37.118 2
PHASORREPORT1 Protocol reporting of phasor data via IEEE 1344 and C37.118, phasors 1-8 2
ANALOGREPORT1 Protocol reporting of analog data via IEEE 1344 and C37.118, analogs 1-8 2
BINARYREPORT1 Protocol reporting of binary data via IEEE 1344 and C37.118, binary 1-8 2
SMAI1–SMAI12 Signal matrix for analog inputs 1
3PHSUM Summation block 3 phase 6
PMUSTATUS Diagnostics for C37.118 2011 and IEEE1344 protocol 1
Section 2 1MRK 502 071-UEN -
Application
54 Generator protection REG670 2.2 IEC and Injection equipment REX060, REX061, REX062
Application manual