ABB REG670 - Section 9 Establishing Connection and Verifying the LON Communication; Communication Via the Rear Ports; LON Communication

Section 9 Establishing connection and verifying the
LON communication
9.1 Communication via the rear ports
M12196-2 v1
9.1.1 LON communication
M12196-4 v5
LON communication is normally used in substation automation systems. Optical fiber
is used within the substation as the physical communication link.
The test can only be carried out when the whole communication system is installed.
Thus, the test is a system test and is not dealt with here.
M14804-3 v5
Control Center
IED IEDIED
Gateway
Star coupler
RER 111
Station HSI
MicroSCADA
IEC05000663-1-en.vsd
IEC05000663 V2 EN-US
Figure 28: Example of LON communication structure for a substation automation
system
An optical network can be used within the substation automation system. This enables
communication with the IEDs through the LON bus from the operator’s workplace,
1MRK 502 073-UUS A Section 9
Establishing connection and verifying the LON communication
Generator protection REG670 2.2 ANSI and Injection equipment REX060, REX061, REX062 101
Commissioning manual