ABB REL 511-C1 2.5 Series - Determine the installed modules

70
Determine the installed modules &KDSWHU
9LHZWKHWHUPLQDOXQLWVWDWXV
 'HWHUPLQHWKHLQVWDOOHGPRGXOHV
 1DYLJDWHWKHPHQXV
This procedure describes how to determine which modules are installed.
3URFHGXUH
 9LHZWKHOLVWRIPRGXOHV
Navigate the menus to:
7HUPLQDO5HSRUW
0RGXOHV
 6FUROOWKHOLVWRILQVWDOOHGPRGXOHVWRYLHZZKDWLVLQVWDOOHGLQ
HDFKVORW
Use the /HIW and/or 5LJKW arrow buttons to scroll the list.
 ,2PRGXOHV
I/O modules are always addressed by references to the slot in which the module resides,
the module type and its order number, that is, which one of several modules of the same
kind is to be addressed. The name is constructed in the following way:
6ORWVORWQXPEHU!PRGXOHW\SH! <DUWLFOHQXPEHU>
For the first binary input module, BIM, mounted in slot 14 the name will be:
6ORW%,0 05.[[
where xx varies depending on the installed BIM variant.
Consequently, for the second BIM module mounted in slot 16 the name will be:
6ORW%,0 05.[[
7DEOH ,2PRGXOHW\SHDEEUHYLDWLRQV
0RGXOHW\SH 0RGXOHW\SHDEEUHYLDWLRQ
Binary input module BIM