ABB REL 551 2.3 Series - Page 49

43
Checking the self supervision signals &KDSWHU
(QHUJLVLQJWKHWHUPLQDO
 &KHFNLQJWKHVHOIVXSHUYLVLRQVLJQDOV
 5HFRQILJXULQJWKHWHUPLQDO
I/O modules configured as logical I/O modules (BIM, BOM, IOM, DCM, IOPSM or
MIM) are supervised. Not configured I/O modules are not supervised.
Each logical I/O module has an error flag that is set if anything is wrong with any signal
or the whole module. The error flag is also set when there is no physical I/O module of
the correct type present in the connected slot.
3URFHGXUH
 %URZVHWRWKHµ5HFRQILJXUH¶PHQX
The Reconfigure menu is located in the local HMI under:
&RQILJXUDWLRQ,2PRGXOHV5HFRQILJXUH
 6HOHFWµ<HV¶DQGSUHVVµ(¶
 6HWWLQJWKHWHUPLQDOWLPH
This procedure describes how to set the terminal time.
 'LVSOD\WKHVHWWLPHGLDORJ
Navigate the menus to:
6HWWLQJV7LPH
Press the ( button to enter the dialog.
 6HWWKHGDWHDQGWLPH
Use the /HIW and 5LJKW arrow buttons to move between the time and
date values (year, month, day, hours, minutes and seconds). Use
the 8S and 'RZQ arrow buttons to change the value.
 &RQILUPWKHVHWWLQJ
Press the ( button to set the calendar and clock to the new values.