ABB REL 551-C1*2.5 - Page 140

131
Serial communication Chapter 9
Data communication
Path in local HMI: Configuration/TerminalCOM/IECCom/Commands/ARBlock
Table 141: Setting parameters for controlling autorecloser command
Path in local HMI: Configuration/TerminalCom/IECCom/Commands/ZCommBlock
Table 142: Configuration/TerminalCom/IECCom/Commands/ZCommBlock
Path in local HMI: Configuration/TerminalCom/IECCom/Commands/LEDReset
Table 143: Setting parameter for controlling the LED reset command
Path in local HMI: Configuration/TerminalCom/IECCom/Commands/SettingGrpn where
n=1-4
Table 144: Setting parameter for controlling the active setting group n command. n=1-4
Path in local HMI: Configuration/TerminalCom/IECCom/Measurands
Table 145: Setting parameter for measurand type
Path in local HMI: Configuration/TerminalCom/IECCom/FunctionType
Parameter Range Default Unit Parameter description
Operation On, Off Off - Operation mode of autorecloser com-
mand. On=Blocked, Off=Released
Parameter Range Default Unit Parameter description
Operation On, Off Off - Operation mode of protection command.
On=Blocked, Off=Released
Parameter Range Default Unit Parameter description
Operation On, Off Off - Operation mode of LED reset command.
On=Blocked, Off=Released
Parameter Range Default Unit Parameter description
Operation On, Off Off - Operation mode of active setting group
command. On=Blocked, Off=Released
Parameter Range Default Unit Parameter description
MeasurandType 3.1, 3.2, 3.3,
3,4, 9
3.1 - Measurand types according to the stan-
dard