5.5.1 Opening and closing Fault Record tool
• To open the Fault Record tool, right-click an IED node in the PCM600 project tree
and select Fault Record Tool.
GUID-06441245-E6DA-4C9F-9363-26CE8D521CB2 V1 EN
Figure 63: Opening the Fault Record tool
• To close the Fault Record tool, click the Close button in the tool.
The Fault Record tool runs in the same process as PCM600 but in a separate window.
Multiple instances of the tool can be run at the same time. Any open tool instances are
closed without confirmation when PCM600 is closed.
1MAC108982-MB E Section 5
Protection and control engineering
615 series ANSI 97
Engineering Manual
To Next Page
Loading...
