ABB Relion 615 series - Adding Symbols into a Display Page

2
1
GUID-A58439A5-575C-4EED-A5A9-77FDECAA9D21 V2 EN
Figure 74: Graphical Display Editor: drawing a busbar and placing busbar
junctions
1
Busbar junction
2 Rotate command
4. Add a link between one busbar junction point and the corresponding symbol or
junction point.
6.1.1.10 Adding symbols into a display page
1. Prepare the body of the single-line diagram by locating symbols to the wanted
positions on the display.
2. Drag the apparatus or transformer symbols into a raster box.
3. Drag the connection symbols into a raster box.
4. Place the junction points.
Do not connect two symbols directly to each other. Instead, add a junction between
them.
5. Use the X and Y coordinates in the Object Properties window to adjust the
placement of symbols in the single-line diagram.
Section 6 1MAC108982-MB E
LHMI engineering
114 615 series ANSI
Engineering Manual