Use X and Y cordinates from the Object
Properties window for every symbol to
adjust the singleline diagram.
GUID-BB90E914-7B02-4D1E-A385-FB6D6305869C-ANSI V1 EN
Figure 75: Graphical Display Editor: adding single-line diagram symbols into a
display page
6.1.1.11 Drawing lines to create links
After the apparatus symbols are placed, lines can be drawn to create links.
1. Click Link to enable direct line drawing.
2. To draw a line, point to the center of the connection point which is visible in two
circles at the end points of a line.
3. Drag the pointer to the destination connection point. Center the pointer again and
release to draw the line.
4. Draw all the necessary line elements.
1MAC108982-MB E Section 6
LHMI engineering
615 series ANSI 115
Engineering Manual
To Next Page
Loading...
