Select Line draw icon
from toolbar to draw
lines between symbols
GUID-795A6797-D4D9-4705-A496-C3FBD771C211-ANSI V1 EN
Figure 76: Graphical Display Editor: drawing a line between symbols
5. To finish the line drawing, click Select on the menu bar.
6.1.2 Bay configuration engineering
A view with a single-line diagram and measurements contains active living objects. The
object values are updated by the protection relay periodically (measurement) or in case of
an event.
Once the symbols are placed on the HMI page, they must be linked to the corresponding
function block in the application configuration, which protects or controls the object that
the symbol on the HMI page represents.
Section 6 1MAC108982-MB E
LHMI engineering
116 615 series ANSI
Engineering Manual
To Next Page
Loading...
