GUID-1DB1A930-A312-4B55-8F68-3D8327A873FB V1 EN
Figure 78: Graphical Display Editor: object properties view for text insertion
6.1.2.2 Creating a complete HMI display page
1. Make a sketch of how to present the single-line diagram.
2. Place the apparatus, transformer and other symbols that are needed for the single-
line diagram into the raster boxes.
3. Add Junction points where needed.
4. Link the apparatus symbols with line elements.
5. In the Object Properties view, adjust the text symbols while writing to north, east,
south or west.
6. Place measurements when needed.
7. Edit the name, unit and the number of the measurements' decimals.
8. Select each object that has a dynamic link and make the link to the corresponding
process object.
1MAC108982-MB E Section 6
LHMI engineering
615 series ANSI 119
Engineering Manual
To Next Page
Loading...
